JOYO Pre amp House 18 Guitar Amplifier Simulators In 1 R-15
The JOYO Preamp House delivers 9 classic guitar amplifier preamps in one pedal, you can fully control both clean and dirty channels, and save your settings to presets.
Turn the dial to select the amp simulation and you can switch from a vintage fender clean to a dirty Mesa-ry drive, 9 different amps & 2 channels.
We dropped in a built-in Impulse Response loaded 4 x 12 cab simulation with 3 controls to turn it off or switch it between the 6.35 out or the balanced XLR output. The Headphone-out uses the cab simulation all the time.
Each preamp has 2 channels, clean / distortion and allows you to save your settings on both channels for all amps. Select between the 2 amp settings Clean or Distortion using the A & B footswitch, pressing both together will give you Bypass mode.
Select from the following Guitar PreAmp Simulations:
- F 65 Twin Reverb
.jpg)
- M JCM 900
- V AC 30
- MB LONESTAR
- MB DUAL RECTIFIER
- EVH 5150
- ENG POWERBALL
- OR TH 200
- OR BE 100
The guitar pedal has a built-in FX LOOP interface for external FX pedals so you can position your modulation, delay, reverb and Eq as you would with your classic head.
The JOYO Preamp House is a user-friendly tone solution, the design is a result of 10 years of our best selling amp simulator guitar effect pedals. The JOYO AmpHouse transforms those classic & vintage guitar amp tones we crave straight onto your board and into your ears, without the expensive amp!
JOYO Amp Simulators can be used as a DI (Direct Interface) directly into a mixing console, audio recording interface, or in front of a clean amp for a tonal drive, pushing your existing amp to a whole new level.
The R Series or Revolution series from JOYO are the 4th generations of guitar effects and all feature some very cool ambient LED lighting that will make your board shine.
The lights can be toggled from a switch on the rear of the pedal..3 modes of lighting are available to adjust when they come on, they are :
- 'Sync' to the footswitch - The LED ambient lighting on the front and rear of the pedal shine bright when the footswitch is pressed, also illuminating the LED effect indicator on the top of the pedal.
- 'Always' - The lights are always on, but the pedal is only activated when you press the footswitch and the LED effect indicator comes on.
- 'Off' - Okay, so Tron may not be your favourite and you want to stick to something a little less futuristic. The lights are off, the LED effect indicator comes on when you stomp on it and activate the pedal.
Controls :
- XLR Output
- 9 Position Amp Selector
- Gain
- Cab Sim toggle
- Treble
- Master Guitar Volume
- Lift Switch
- Footswitch A Clean
- Footswitch B Distortion
- Mono Input / Output
- Headphone output
- USB for firmware updates.
- Groovy Ambient Lighting
Specifications:
- Dimensions: 130mm * 110mm * 50 mm
- Weight:450g
- Input Impedance: 1MΩ
- Output Impedance: 600Ω
- XLR Output Impedance: 600Ω
- Sample Rate 44.1l
- Sample Resolution : 24bit
- Rated Current Consumption: 320mA
- Delay Time: about 500ms
- Working Voltage: DC 9V (center minus)
